AR15/M16 Gen 2 Non-Rotate Trigger/Hammer Pins .154 Dia

$29.95

AR15/M16 Gen 2 Non-Rotate Trigger/Hammer Pins .154 Diameter

Non-rotating trigger/hammer pin sets which are designed to sit flat against the side of your AR15 receiver. Toughest pins produced.

*Disclaimer: These components may have application in semi-auto or full-auto firearems. They will not convert a semi-auto firearm to full-auto or burst operation. When used in NFA applications these parts are replacement parts and are intended to be installed by a qualified gunsmith in existing and legally owned NFA firearms. Attempting to convert a firearm may constitute a violation of Federal or State law. All NFA requirements must be followed.

Free shipping on orders over $175.00!

  • Check Mark Made in America
  • Check Mark Secure Checkout
SECURE CHECKOUT
  • Visa Card
  • MasterCard
  • American Express
  • Discover Card

Description

AR15/M16 Gen 2 Non-Rotate Trigger/Hammer Pins .154 Diameter

Non-rotating trigger/hammer pin sets which are designed to sit flat against the side of your AR15 receiver. Toughest pins produced. Designed to withstand the stresses generated by high-impact suppressed fire. Trigger & hammer pins are stainless steel and retainer side plates are steel with a black nitride finish.

KNS non-rotating trigger/hammer pin sets prevent wear on your AR lower and prevent your pins from walking out of your receiver. Kit includes an installation guide tool & 2 Torx wrenches. No permanent modification to your gun is required.

Torque spec for screw-tightening should not exceed 11 inch-lbs, 8 inch-lbs is recommended.

SKU: KNS-1

Reviews

There are no reviews yet.

Be the first to review “AR15/M16 Gen 2 Non-Rotate Trigger/Hammer Pins .154 Dia”